Control Panels

Cold Room Control Panel Part Winding

Introduction

The CRC- 2052 is single set point cold room controller. The Sub-Zero CRC- 2052 is aesthetically superior versions of their predecessors.

Features:

The controller controls the defrost in the system based on either an electrical heater where the compressor is stopped, or at cycle inversion using warm gas where the compressor keeps on working.

There are safety features which include shutting down the system incase of a fault from a pressure control or similar device.

A series of “safety controls” (delay at start-up, minimum disable time between activation) protects the compressors from close starts. In case of probe error or temperature alarm, the instrument signals the event through acoustic signal and by closing the relay contact. By pressing the mute key, the buzzer is silenced.

A number of parameters are displayed alphanumerically to set up the instrument for each specific function.

Computer connectivity over RS485 and Remote monitoring(optional)

Single Operation Quick Freeze Mode (Press QF key for 2 sec), set system in quick freeze mode which is time based for that period new set point will be lower than running set point and system will try to achieve that set point, after time period over set point will be normal set point